Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Garage Door Before & After in Pembroke Pines, FL
Any company can say they do good work. We’d rather show you. Below you’ll find real transformations from garage door jobs across Pembroke Pines, from Chapel Trail to Pembroke Falls to The Knolls. Each one follows the same pattern: a door that quit, a written price before we touched anything, and a photo record of what we found and what we fixed. You’ll see failed torsion springs, rotted bottom panels, outdated openers, and doors that needed a full reset. Here’s the evidence.
Recent Transformations
Torsion Spring Replacement on a Two-Car Door in Chapel Trail
[Placeholder: close-up of snapped spring at coil break, side-by-side with new spring mounted and door level at half-open]
A homeowner off Johnson Street heard what she described as “a gunshot from the garage” at 6:40 on a Tuesday morning. The right torsion spring had snapped clean at the coil. We measured the old spring at 0.250-inch wire diameter, matched the specs to the door’s weight, and installed a new pair within two hours. The door now lifts with one hand and sits level at every point of travel.
Garage Door Opener Replacement in Pembroke Falls
[Placeholder: old opener unit showing burned logic board, side-by-side with new belt-drive opener on ceiling mount]
The old chain-drive opener was 14 years old and the logic board had stopped responding to both remotes and the wall button. Rather than patch an outdated unit, we quoted a LiftMaster belt-drive replacement with a new wall console and two remotes, then removed and disposed of the old unit. The garage is quieter than the laundry room now. That’s the bar.
Bottom Panel Replacement in The Knolls
[Placeholder: bottom panel with visible rot and peeling weather seal, side-by-side with the replaced panel and new bottom seal]
Years of South Florida runoff from a downspout had rotted the bottom panel of an otherwise solid Clopay door. Replacing the full door wasn’t necessary, and we told the homeowner that before quoting anything. We ordered a factory-matched panel, installed it with a new bottom seal, and documented the fit. The door closes flush against the slab again, and the estimate the homeowner approved before we started is exactly what they paid.
Full Door Reset After Hurricane-Damaged Track in SilverLakes
[Placeholder: door hanging at an angle with visible track damage, side-by-side with the fully restored door in closed position]
Storm winds had forced the door out of its rails and bent both vertical tracks. The cables were frayed and one roller had shattered. We removed the door carefully, replaced the damaged track sections, installed new cables and rollers, and re-hung the door. Then we photographed every step, because “it works now” means more when you can see what was wrong.
Frozen Trolley Carriage and Limit Switch Failure in Westfork
[Placeholder: close-up of seized carriage on opener rail, side-by-side with the carriage freed and door stopped correctly at both limits]
The opener motor ran, but the door only moved six inches before reversing. The trolley carriage had seized from years of dust and humidity, and the limit switch had lost its calibration. We freed the carriage, cleaned the rail, replaced the limit switch assembly, and reset the open and close positions. The door now stops exactly where it should, every cycle.
New Door Installation for a Homeowner Who Was Done Repairing
[Placeholder: old door with visible dents and hinge sag, side-by-side with the new door installed and solar panels catching afternoon light]
After 19 years and three repair calls from other companies, the homeowner in Pembroke Pines had enough. We measured, quoted a new Amarr steel-back door with upgraded hinges and a new weather seal, and scheduled the install at a time that worked for her. The old door was hauled away, the new one was hung and balanced, and the before and after photos tell the rest. The difference is not subtle.
Want Results Like These?

Every job above started the same way: a phone call, an inspection, and a written price before any work began. No surprises, no “well, once we started we found more.” If your garage door in Pembroke Pines needs work, call (954) 280-1425 and we’ll come out, find the problem, and quote you a flat price on paper before anything gets touched.
Written by Marcus Deller, Owner at Servo Garage Doors Pembroke Pines, serving Pembroke Pines since 2015.






Before
After
Before
After
Before
After